A cold evening on the pitch. You turn the knob on the CP Plus, and the Truma does nothing. Before you assume a defect: in most cases one of a few causes is behind it, and you can fix most of them quickly. The Truma Combi family comes as gas (4/6), gas-electric (4E/6E), diesel (D4/D6) and diesel-electric (D4E/D6E). This checklist applies to all of them, whatever motorhome, campervan or caravan your Combi is fitted in.
Quick checklist
- 1. Is there fuel? Diesel Combi: check the tank level. Gas Combi: is the bottle full and the valve open?
- 2. Is the leisure battery charged enough? On undervoltage the Combi switches off.
- 3. Right energy mode? Electric and mix need mains hook-up.
- 4. Error code on the CP Plus? Read it, look it up, remove the cause, acknowledge it.
- No hot water? Check the FrostControl (separate section below).
Cause 1: no fuel, low diesel or the gas is off
Diesel Combi (D4/D4E/D6/D6E): it takes its fuel straight from the vehicle tank. So that the heater cannot leave you unable to drive, the fuel draw is designed to stop at a low tank level. The heater then gets no more diesel, although the vehicle still runs. If the fuel gauge is low and the heater will not start: fill up first, then keep looking.
Gas Combi (4/4E, 6/6E): if the Truma is not working on gas, the classic causes are an empty gas bottle and a closed valve. Check the bottle valve and the shut-off tap. After a bottle change, the first start attempt can fail until the line has filled again. A second attempt is then normal. If you would rather not guess the level: with a gas sensor (Truma Level Control or Mopeka), CampMatic shows it directly in the app. See Truma Level Control in CampMatic and Mopeka: check your gas bottle from anywhere.
Cause 2: leisure battery voltage too low
The Combi's burner, air circulation and electronics run on the 12 V leisure battery. If the voltage is too low, for example after several days parked without sun or with a tired battery, the heater will not start or goes into fault. The fix: plug into mains hook-up, charge the battery, then restart. If you leave your vehicle parked for longer, keep an eye on the voltage. How to do that remotely: BM2 battery monitor in an app, from anywhere.
Cause 3: wrong energy mode selected
The electric versions of the Combi (4E/6E for the gas models, D4E/D6E for diesel) offer gas or diesel, electric and mix. In electric or mix mode they need 230 V mains hook-up. Without a connected and fused hook-up cable, nothing heats in pure electric mode. On a pitch without hook-up, switch to diesel or gas. What the modes do in detail: Control the Truma Combi D6 & D6E from your phone.
Cause 4: fault with an error code on the CP Plus
When the Combi goes into fault, the CP Plus shows an error code, for example E 517 H or W 255 H. That gives you something to work with:
- Note the code and look it up: what the codes mean and what you can do about each one is in the list of Truma error codes, split into Combi gas and Combi D.
- Remove the cause, then acknowledge: press the rotary/push knob on the CP Plus. According to Truma, switching the CP Plus off and on does not clear a gas fault; it locks the heater for 15 minutes. RESET → PR SET is not a fault reset either. What helps instead: Truma Combi reset: clearing faults, RESET on the CP Plus, reset button.
- After a long idle period the diesel burner may need several start attempts until fuel reaches it again. One or two repeats are no cause for alarm.
- If the fault persists or keeps coming back: contact a Truma service partner. The burner and fuel system are not for DIY repairs.
No display, just a red or yellow light flashing? On the analogue CP classic control panel there are LEDs instead of codes: Truma Combi flashing red, yellow or green: what the light means.
Heater won't ignite or fire up, or keeps clicking
Many people describe a clicking sound at start-up as an ignition attempt. Truma's documents do not link noises to any cause. What they do document are the causes when no flame comes or the flame is not detected:
- Combi gas (codes such as E 507 H, E 516 H, E 517 H or E 112 H to E 212 H): gas bottle empty, bottle or quick-closing valve closed, regulator iced up, too much butane (according to Truma unsuitable for heating, especially below 10 °C; in the UK, Calor's blue bottles are butane, the red ones propane), combustion air inlet or exhaust outlet blocked by snow, ice or leaves, regulator faulty.
- Combi D (for example E 122 H): lack of fuel because there is little diesel, the tank has run dry or the vehicle is on a slope; above 1500 m without an altitude kit. According to Truma, the Combi D makes two start attempts of two minutes each every time it is switched on, then goes into fault. After too many unsuccessful starts it locks. According to the Combi D manual, only customer service can lift this lock.
The codes one by one: Combi gas and Combi D in the error code list.
Heater keeps switching off
According to Truma, these are the main causes:
- Battery voltage too low: codes on the CP Plus such as W 24 H, W 302 H, or W 160 H on the Combi D. Charge the battery, check the contacts, replace an old battery.
- Gas runs out or the flame is unstable: E 121 H, or E 507 H, E 516 H, E 517 H. Check the bottle, regulator and flue.
- Window above the flue open: W 42 H or W 412 H, on the Combi D E 162 H. Close and lock the window.
- Warm air builds up: not all warm air ducts connected, outlets or the return air intake blocked (W 18 H, W 402 H, Combi D W 150 H). On the Combi D a temperature switch can open (W 163 H): let it cool down; if it happens often, contact Truma Service.
- Target temperature reached: if the temperature you set is lower than the room temperature, the Combi does not heat. That is not a fault.
Fan running, but no heat
If air comes out but no heat, check these points:
- After-run: according to Truma, the fan keeps running after the heater is switched off. This protects the Combi from overheating due to heat build-up and cannot be switched off. For the analogue control panel, Truma gives a maximum of 5 minutes.
- Warm air not arriving: ducts loose or kinked, or outlets blocked. The CP Plus then shows W 18 H or W 402 H (Combi D: W 150 H).
- Electric without mains hook-up: if the 230 V is missing, the Combi E shows W 45 H or W 407 H, and the Combi D E shows W 164 H. If the 230 V overheating protection has tripped, it has to be reset with the reset button, see Truma Combi reset: the reset button.
All codes with fixes: Truma error codes: list of all E and W codes.
Truma Combi not heating water: check the FrostControl
If it gets warm but no hot water comes, or water runs out under the vehicle, the explanation is usually the FrostControl safety valve. At temperatures around freezing it opens automatically and drains the water heater so that nothing freezes and bursts. That is intended, not a defect. It can only be closed again once it is warm enough at the valve. So: heat the interior, close the valve, refill the water system, then switch on hot water. Step by step: Draining a Truma Combi: FrostControl and hot water in winter.
Spotting a fault sooner, from anywhere
The annoying case is the one you only discover on arrival: heater in fault for hours, vehicle cold. With CampMatic you can see in the app, wherever you are, whether the Combi is running or in fault, along with the room temperature and its history. With a CP Plus the app shows the status “Error”. With a Truma iNet X Panel it shows the code and an explanation.
You get notifications when the room temperature drops below or rises above a limit, when the target temperature is reached, when the heater switches on or off and when the box goes offline. An alert about a low interior temperature can be the first sign that the heater has stopped heating. You see the fault itself when you open the app; CampMatic does not send a separate message for it. You can change the temperature and operating mode remotely, but you can only acknowledge a fault on the control panel. With the 4G version this also works in winter storage, with no WiFi at all.
Worth knowing: CampMatic fits all compatible Truma Combi heaters, Combi 4/4E/6/6E (gas), D4/D4E/D6/D6E (diesel) and Vario Heat, with CP Plus firmware C4 or F4 (Vario Heat: P5) or with a Truma iNet X Panel, whatever the vehicle. The boxes: CampMatic for Truma CP Plus and CampMatic for Truma iNet X. The overview: Control your caravan heater from an app.
VW Grand California
The same checklist applies in the VW Grand California. One point causes confusion there: camping mode is not needed for the heater. The Truma runs independently of it, so there is nothing to switch over before heating. You heat on the CP Plus, not on the digital control panel in the living area. That panel only shows levels, battery and solar.
Frequently asked questions
The heater worked yesterday but not today. What should I check first?
In this order: battery level after the night, fuel (gas valve or fuel gauge), selected energy mode, error code on the CP Plus. That explains the large majority of cases.
How long should the start take?
A few minutes, including the fan start-up phase and ignition, is normal. The diesel burner takes noticeably longer than the gas models, especially on the first start after a long break. Only when the CP Plus reports a fault has the start attempt actually failed.
Can CampMatic repair a faulty heater?
No. But it makes problems visible before they get expensive: instead of a frozen water system in winter storage, you get a frost warning on your phone and can react. And day to day it saves you many trips to the vehicle just to check whether the heater is running.
Summary
When your Truma heater is not working, it is almost always one of four causes: no fuel (low diesel or gas off), a weak leisure battery, the wrong energy mode or a fault with an error code. Plus the FrostControl special case for hot water. The checklist takes a few minutes. And if you monitor the Combi remotely with CampMatic, you will see the problem on your phone in future rather than discover it on a cold pitch.
→ CampMatic for Truma · WiFi — status, frost warning & remote control, from €149
→ CampMatic for Truma · 4G — the same with no WiFi at all (+€60)
Further reading: