Back to overview Guide

Draining a Truma Combi: FrostControl and hot water in winter

Reading time: 7 min
CampMatic
Draining a Truma Combi: FrostControl and hot water in winter

This is how to drain the Truma Combi water heater: switch off the power to the water pump, open the hot water taps, put a container that holds 10 litres under the drain outlet and open the FrostControl. To do that, turn the rotary switch through 180° until it clicks into place. The push button pops out and the water drains.

Below about 3 °C at the valve, the FrostControl also opens by itself. Here you will find how the valve works, how to close it again, why the hot water symbol flashes and how to heat without water in winter.

At a glance

  • FrostControl: a safety and drain valve that needs no power. It opens automatically below about 3 °C at the valve.
  • Closing: only possible again above about 7 °C at the valve.
  • Frost period without use: according to Truma, the water heater must be drained in any case.
  • Heating without water: allowed, as space heating only with hot water switched off.
  • Flashing hot water symbol: the set water temperature has not been reached yet. That is not a fault.

What the FrostControl does

The FrostControl is a safety and drain valve that works without power. If there is a risk of frost, it automatically drains the water heater through a drain outlet. If the pressure in the system is too high, it releases it in bursts via the safety valve.

  • Rotary switch: in the "operation" position it is parallel to the water connection.
  • Push button: pushed in means closed, popped out means draining. If the blue push button is pressed in, the valve is closed.
  • Drain outlet: it leads outside through the vehicle floor. Keep it free of slush, ice and leaves.

Below about 3 °C at the valve it opens by itself and the button pops out. It can only be closed again above about 7 °C at the valve.

Important: the Combi itself has no built-in frost protection. According to Truma, the operator is responsible, for example by using the FrostControl. The UK version has a drain valve with a lever instead of the FrostControl, and that valve does not protect against frost damage.

Draining the Combi by hand: step by step

  1. Switch off the power to the water pump.
  2. Open the hot water taps in the kitchen and bathroom.
  3. Put a container that holds at least 10 litres under the drain outlet.
  4. Open the FrostControl: turn the rotary switch through 180° until it clicks into place. The push button pops out.
  5. Check that all 10 litres have drained out.

Truma is clear on this: if the vehicle is not used during a period of frost, the water heater must be drained in any case. The manual adds that there is "no warranty claim for frost damage".

Even if you only use cold water, the water heater fills up as well. So you still have to drain it when there is frost. Whether the fresh water tank and pipes also drain when you open the FrostControl depends, according to Truma, on how the vehicle manufacturer installed them. Check your vehicle's manual for this.

Closing the FrostControl and refilling

  1. Turn the rotary switch to "operation".
  2. Press the push button until it clicks into place.

If it is colder than about 7 °C at the valve, switch the heater on first. After a few minutes, the installation space and the FrostControl are warm enough to close it.

Common problems

  • Opens after the heater is switched off: it is below about 3 °C at the valve. Switch the heater back on or use the heating element.
  • Will not close: it is below about 7 °C, or the rotary switch is not set to "operation".
  • Water runs out, the water heater will not fill: the valve is open.
  • Dripping at the outlet: the water pressure is too high. The pump may supply no more than 2.8 bar; on a mains water connection you need a pressure reducer.

The FrostControl heating element is available as an accessory. When the Combi is switched on, it warms the valve to about 10 °C and draws no more than 0.4 A. That lets you fill the water heater sooner.

For maintenance, operate the FrostControl at least twice a year so it does not scale up or stick. Truma's tip: put a thermometer near the valve. Where it is fitted, it can be colder than in the living area.

Heating without water in winter

That is fine. According to Truma, the Combi may heat the interior with an empty water heater. This applies to the gas Combi, to the Combi E in gas, electric and mixed mode, and to the Combi D. The condition: space heating only, hot water off.

  • Drain the water heater properly: any water left in it can get very hot very quickly, and the heater then reports a water overtemperature. That is why Truma recommends leaving the FrostControl open when running without water.
  • No hot water mode with an empty water heater: this causes a fault, #17 on the gas Combi, #151 or #152 on the Combi D. Switch the heater off, let it cool down and fill the water heater.

The other way round: if the water heater is full, the water is heated automatically along with the space heating.

Why the hot water symbol flashes

Usually this is not a fault. According to the manual, the symbol flashes as long as the set water temperature has not been reached. The heating symbol works the same way: it flashes until the room temperature is reached.

Other flashing displays mean something else. The clock symbol flashes when the time switch is active. If an error code such as 507, 516 or 517 is flashing, a 15-minute lockout is running.

On the CP Plus, you choose the hot water level: eco (40 °C), hot (60 °C) or boost. Boost is not available on the diesel Combi.

Gas or diesel: what is different

There is no difference when draining. The gas Combi and the Combi D have the same FrostControl, operated the same way, and a 10-litre water heater. The differences are in winter operation:

  • Water heating time: according to the technical data, about 23 minutes on gas and about 20 minutes on the Combi D.
  • Fuel: for the Combi D, the manual specifies winter diesel in winter and arctic diesel at −20 to −30 °C.
  • Lay-up: the Combi D should also run for about 10 minutes once a month outside the season.
  • Start lockout: after 15 unsuccessful start attempts, the Combi D locks. Only the service team can release it.
  • Power: the Combi D needs more power than the gas version.

Spotting frost early with CampMatic

The FrostControl only reacts once it is cold at the valve. If you want to know beforehand how cold it is getting in the vehicle, a remote check helps:

  • Room temperature in the app: with CampMatic for Truma CP Plus or CampMatic for Truma iNet X you can see the room temperature in the app at any time, even when you are away. And you can switch the heater on remotely.
  • Frost alert via RuuviTag: a RuuviTag measures temperature and humidity. In CampMatic you set a threshold, for example +3 °C, and get an alert via Telegram or email if it gets colder. Put it in a cold spot, for example near the FrostControl.
  • Without Truma control: CampMatic Guard monitors temperature, gas and the leisure battery in any camper, whatever heater is fitted.

Frequently asked questions

How do I drain the Truma Combi water heater?
Pump off, hot water taps open, container under the outlet, open the FrostControl (rotary switch through 180°). Then check that all 10 litres have drained out.

Why is the hot water symbol flashing on the CP Plus?
The set water temperature has not been reached yet. Once the water is hot, the flashing stops.

Can I run the Truma Combi without water?
Yes, as space heating only with hot water switched off. The water heater should be properly empty. Truma recommends leaving the FrostControl open.

At what temperature does the FrostControl open?
Below about 3 °C at the valve. It can only be closed again above about 7 °C.

The FrostControl will not close. What should I do?
Switch the heater on and wait a few minutes until it is above 7 °C at the valve. Also check that the rotary switch is set to "operation".

→ CampMatic for Truma CP Plus · WiFi — €149

→ CampMatic for Truma iNet X · WiFi — €149

→ CampMatic Guard WiFi — €89

Further reading: